Bryank930
New Member
- Joined
- Mar 15, 2019
- Messages
- 15
- Reaction score
- 1
- Country
- United States
- Dash Cam
- B1W
I have this kit installed in my car for my B1W, I only have the red and ground wires hooked up, and up until today everything has been working fine. When I started my car today, I noticed the green light on the back of the camera was very dim. I tried unplugging the micro USB, and plugging it back into the camera, that didn't help. I disconnected the fuse tap and plugged it back in, that didn't help either. I have the low-volt cutoff on the lowest setting thinking it might have been tripping because of voltage sag while cranking the car. But even with the car running, disconnecting the fuse tap and reconnecting doesn't change anything.
I haven't had a whole lot of time to pull it all apart and really dig into it, but does this sound defective? Do I need to connect both the red and yellow to +12v?
xposted to Hardwire forum
@estore009
I haven't had a whole lot of time to pull it all apart and really dig into it, but does this sound defective? Do I need to connect both the red and yellow to +12v?
xposted to Hardwire forum
@estore009