Hi there. I recently purchased two Lukas 7950s in large part due to the positive comments I read on this site. So thanks for that!
Both units are b-type. I purchased the ODBII add-on for my wife's 2013 Hyundai Santa Fe. The Lukas site says that their unit is compatible with this car. Installation went fine, except for the fact that the extra data I expected would be transmitted by the ODBII link is not visible. The bottom section of the camera video looks no different on this car than it does on the camera I installed without the OBDII add-on.
Can you guys offer any troubleshooting tips? I have checked that the cable is connected on both ends. The ODBII end is illuminated red when the car ignition is on. Thanks in advance for any help.
Edit: Perhaps the firmware on the camera is the problem. Since I bought b-type, the camera may not be looking for the OBDII data. I wonder if it is possible to flash the b-type camera with d-type firmware in order to enable this functionality.
Both units are b-type. I purchased the ODBII add-on for my wife's 2013 Hyundai Santa Fe. The Lukas site says that their unit is compatible with this car. Installation went fine, except for the fact that the extra data I expected would be transmitted by the ODBII link is not visible. The bottom section of the camera video looks no different on this car than it does on the camera I installed without the OBDII add-on.
Can you guys offer any troubleshooting tips? I have checked that the cable is connected on both ends. The ODBII end is illuminated red when the car ignition is on. Thanks in advance for any help.
Edit: Perhaps the firmware on the camera is the problem. Since I bought b-type, the camera may not be looking for the OBDII data. I wonder if it is possible to flash the b-type camera with d-type firmware in order to enable this functionality.
Last edited: